700R4 Yoke

58chev · Etobicoke On Rod-side Member

700R4 Yoke

Mr Samis · Furnace Tech Brighton On Member

I have one in Brighton. I would trade for a plug to take its place.

33 guy · Mississauga On Rod-side Member Ford guy

I was under the impression that they were the same as t 350 and 400's

Chevy Dan · member

33 guy wrote:
I was under the impression that they were the same as t 350 and 400's

I don't believe T350 and T400's use the same yoke.

33 guy · Mississauga On Rod-side Member Ford guy

Uses the same yoke as a turbo 350 27 spline

turbo 400 has 32 splines

Lightspeed Mike · http://lightspeedmetaldesign.com/

The spline is the same, but I think the yokes are longer. At least the one I have is.

Chevy Dan · member

Question to the original poster.

Will a TH350 yoke work with your trans/application or are you needing a yoke that is longer than a typical (no idea what I mean by that) TH350 yoke?

rochie · London On, ELTA Member

Frank what came out of the chev….was it a 2 speed glide, if so the yoke should fit the 700

58chev · Etobicoke On Rod-side Member

Sorry folks I have not been around much..

rochie wrote:
Frank what came out of the chev….was it a 2 speed glide, if so the yoke should fit the 700

Actually a TH350 is what came out. Guess I'll have to pull the shaft(s) out to see.

If I recall it was short but the front shaft is mounted with the bearing and should have little movement.

ThanX guys I will check into it.

58chev · Etobicoke On Rod-side Member

Finally had time to pull the driveshaft out of my car and fit the yoke on the transmission.

So I no longer need a yoke, it fit.

Now time to clean up the two piece driveshaft and eventually get it shortened.